![]() WHAT ARE WE INTO HERE FELLAS? We're preparing to march in, separate and pull the Torq. I retorqued (to factory) the 8 external 9/16 bolts that circle the output shaft and the leak got a little worse. Apparently the large O-ring/seal between the carrier and divider housing has failed. It's NOT output shaft seal, scav.pump housing gasket or hyd. leak (engine running) at the rear center of the Torque Divider. Obviously we're working a number of issues, but first: Has anyone come across any Service/Repair publications, for the d6c, you'd consider "Better" than Caterpillar's? Next: We've tracked down a steady hyd. Luckily I've rounded up an authentic Cat shop Manual (800+pgs) but it's clear we're going to need advice from the "Experienced" A good buddy of mine got one for his farm and I'm helping him go through it. ![]() I'm new to this forum and new to the d6c Cat.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |